PDA

Επιστροφή στο Forum : CISCO 887VA σε γραμμή VDSL της VODAFONE



stinggr
17-09-16, 22:42
Προσπαθώ να φτιάξω το configuration σε ενα CISCO 887VA αλλά δεν λέει να συνδεθεί με τίποτα.
Κάθε βοήθεια είναι ευπρόσδεκτη, γιατι έχω πελαγώσει.
Με τον ΟΤΕ ποτέ δεν είχα πρόβλημα. Το router δούλευε μια χαρά. Τώρα δεν ξέρω τι συμβαίνει.
Παρακάτω έχω το configuration του 887VA.

---------------------------------------------------------------------

sh run
Building configuration...


Current configuration : 2348 bytes
!
version 15.6
service timestamps debug datetime msec
service timestamps log datetime msec
no service password-encryption
!
hostname C887VA
!
boot-start-marker
boot-end-marker
!
!
enable secret 5 $1$yph1$VSs9XpIg0TwPuJrXE6QK51
!
no aaa new-model
ethernet lmi ce
clock timezone GMT 2 0
!
!
!
!
!
!
!
!
!
!
!
!
!
!
!
!
!




!
!
ip dhcp pool ccp-pool
dns-server 10.10.10.1
!
!
!
ip domain name ultranet.prv
ip cef
no ipv6 cef
!
!
!
!
!
multilink bundle-name authenticated
!
!
!
!
!
!
!
license udi pid C887VA-K9 sn FCZ184090HF
!
!
object-group network local_lan_subnets
10.10.10.0 255.255.255.128
!
username stzanlis privilege 15 secret 5 $1$F5iO$54qrkz8jUxeFWQVwXQ7L4.
!
!
!
!
!
controller VDSL 0
operating mode vdsl2
!
!
class-map type inspect match-all INTERNAL_DOMAIN_FILTER
!
!
!
!
!
!
!
!
!
!
!
interface ATM0
no ip address
shutdown
no atm ilmi-keepalive
!
interface Ethernet0
description PrimaryWANDesc_
no ip address
pppoe enable group global
pppoe-client dial-pool-number 1
!
interface FastEthernet0
no ip address
!
interface FastEthernet1
no ip address
!
interface FastEthernet2
no ip address
!
interface FastEthernet3
no ip address
!
interface Vlan1
ip address 10.10.10.1 255.255.255.0
ip nat inside
ip virtual-reassembly in
!
interface Dialer1
description PrimaryWANDesc__Ethernet0
ip address negotiated
ip mtu 1452
ip nat outside
ip virtual-reassembly in
encapsulation ppp
dialer pool 1
dialer-group 1
ppp authentication chap pap callin
ppp chap hostname xxxxxxxx@hol.gr
ppp chap password 0 xxxxxxxxxxx
ppp pap sent-username xxxxxxx@hol.gr password 0 xxxxxxxxx
ppp ipcp dns request
no cdp enable
!
ip forward-protocol nd
ip http server
no ip http secure-server
!
!
ip dns server
ip nat inside source list nat-list interface Dialer1 overload
ip route 0.0.0.0 0.0.0.0 Dialer1
!
ip access-list extended nat-list
permit ip object-group local_lan_subnets any
deny ip any any
!
dialer-list 1 protocol ip permit
!
!
control-plane
!
!
!
mgcp behavior rsip-range tgcp-only
mgcp behavior comedia-role none
mgcp behavior comedia-check-media-src disable
mgcp behavior comedia-sdp-force disable
!
mgcp profile default
!
!
!
!
!
!
!
line con 0
no modem enable
line aux 0
line vty 0 4
login local
transport input telnet ssh
line vty 5 15
login local
transport input telnet ssh
!
scheduler allocate 20000 1000
!
end

---------------------------------------------------------------------


C887VA#sh ip int brie
Interface IP-Address OK? Method Status Protocol
ATM0 unassigned YES NVRAM administratively down down
Dialer1 unassigned YES NVRAM up up
Ethernet0 unassigned YES NVRAM up up
FastEthernet0 unassigned YES unset down down
FastEthernet1 unassigned YES unset down down
FastEthernet2 unassigned YES unset down down
FastEthernet3 unassigned YES unset up up
NVI0 unassigned YES unset up up
Virtual-Access1 unassigned YES unset up up
Vlan1 10.10.10.1 YES NVRAM up up
C887VA#
C887VA#
C887VA#sh controller vdsl 0
Controller VDSL 0 is UP

Daemon Status: Up

XTU-R (DS) XTU-C (US)
Chip Vendor ID: 'BDCM' 'IFTN'
Chip Vendor Specific: 0x0000 0xD102
Chip Vendor Country: 0xB500 0xB500
Modem Vendor ID: 'CSCO' ' '
Modem Vendor Specific: 0x4602 0x0000
Modem Vendor Country: 0xB500 0x0000
Serial Number Near: FCZ184090HF C887VA-K 15.6(2)T
Serial Number Far:
Modem Version Near: 15.6(2)T
Modem Version Far: 0xd102

Modem Status: TC Sync (Showtime!)

DSL Config Mode: VDSL2
Trained Mode: G.993.2 (VDSL2) Profile 8b
TC Mode: PTM
Selftest Result: 0x00
DELT configuration: disabled
DELT state: not running

Full inits: 1
Failed full inits: 0
Short inits: 0
Failed short inits: 0

Firmware Source File Name
-------- ------ ----------
VDSL embedded VDSL_LINUX_DEV_01212008

Modem FW Version: 130205_1433-4.02L.03.A2pv6C035j.d23j
Modem PHY Version: A2pv6C035j.d23j
Trellis: ON ON
SRA: disabled disabled
SRA count: 0 0
Bit swap: enabled enabled
Bit swap count: 0 0
Line Attenuation: 0.0 dB 0.0 dB
Signal Attenuation: 0.0 dB 0.0 dB
Noise Margin: 6.2 dB 6.2 dB
Attainable Rate: 32204 kbits/s 3553 kbits/s
Actual Power: 17.1 dBm 6.5 dBm
Per Band Status: D1 D2 D3 U0 U1 U2 U3
Line Attenuation(dB): 20.6 63.3 N/A 8.9 48.9 N/A N/A
Signal Attenuation(dB): 20.6 63.3 N/A 8.6 50.2 N/A N/A
Noise Margin(dB): 6.2 6.2 N/A 7.6 6.1 N/A N/A
Total FECC: 281 0
Total ES: 3 0
Total SES: 0 0
Total LOSS: 0 0
Total UAS: 281 281
Total LPRS: 0 0
Total LOFS: 0 0
Total LOLS: 0 0


DS Channel1 DS Channel0 US Channel1 US Channel0
Speed (kbps): 0 31907 0 3506
SRA Previous Speed: 0 0 0 0
Previous Speed: 0 0 0 0
Reed-Solomon EC: 0 281 0 0
CRC Errors: 0 5 0 0
Header Errors: 0 21 0 0
Interleave (ms): 0.00 8.00 0.00 7.00
Actual INP: 0.00 0.01 0.00 0.10

Training Log : Stopped
Training Log Filename : flash:vdsllog.bin


C887VA#ping 8.8.8.8
Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 8.8.8.8, timeout is 2 seconds:
.....
Success rate is 0 percent (0/5)
C887VA#ping 4.2.2.2
Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 4.2.2.2, timeout is 2 seconds:
.....
Success rate is 0 percent (0/5)
C887VA#

SfH
18-09-16, 13:28
Εντύπωση μου κάνει να δούλευε το παραπάνω config, καθώς δεν έχεις ορίσει ούτε vlan για ptm, ούτε pvc για atm.

Δοκίμασε το εξής :



interface Ethernet0
no pppoe enable group global
no pppoe-client dial-pool-number 1
exit
interface Ethernet0.835
enc dot 835
pppoe-client dial-pool-number 1

@ ADSLgr.com All rights reserved.