Downloads: OpenWag200 build 0.11 Annex A(beta)

Εναλλακτικό firmware για το Linksys Wag200 βασισμένο στην τελευταία διαθέσιμη
επίσημη version 1.01.09

Προσθέτει πολλές έξτρα λειτουργίες, προσοχή είναι beta, διαβάστε τις οδηγίες.
Important Upgrade Notes

posted Oct 18, 2009 - LANGUAGE SETTING MUST BE SET TO ENGLISH PRIOR TO FLASHING THE SOFTWARE.
- MySetup variable names were changed in 0.9 - you must configure MySetup part of firmware once again after upgrade !
- If your router seems to hang during the upgrade (upgrade progess bar reaching 100%, and upgrade LED is still flashing red, nothing else happens) - wait at least 5-10 minutes before manually restarting the router !
- Do NOT upgrade via remote internet or wireless connection ! Use only wired LAN connection to upgrade your router ! Double check file sizes and MD5 checksums before upgrading!
- ANNEX B releases are NOT tested - we don't have ANNEX B router ...
- Reboot the router before upgrading to make sure it has enough free memory.
- Disconnect all clients from the router before upgrading. Make sure NO wireless clients attempt to associate with the Gateway until the upgrade process is complete.

And finally, as always: if you are afraid of bricking your WAG200, or don't know how to install and use JTAG - DO NOT REFLASH WITH THIS FIRMWARE ! THIS IS EXPERIMENTAL, BETA SOFTWARE !

0.11 ChangeLog

Changes since 0.10:
- Added: Ability to use Public-Key Authentication for SSH
- Added: UI to change gateway IP address for DHCP clients
- Added: UPnP configuration UI
- Added: Network interface statistics UI
- Added: AR7 DSL Modem Statistics/Feature Control UI
- Fixed: MySetup tab doesnt exist on all pages
- Fixed: mtd5 not synced before reboot
- Fixed: DHCP client table is always empty
- Fixed: DHCP server for WLAN doesnt start at boot when routed WLAN is enabled
- Fixed: Poor PPTP performance due to continual debugging
- Minor UI improvements and cleanups
http://openwag200.org/