Downloads: OpenWag200 build 0.10 Annex A(beta)

Εναλλακτικό firmware για το Linksys Wag200 βασισμένο στην τελευταία διαθέσιμη
επίσημη version 1.01.09

Προσθέτει πολλές έξτρα λειτουργίες, προσοχή είναι beta, διαβάστε τις οδηγίες.
Important Upgrade Notes

posted Oct 18, 2009 - LANGUAGE SETTING MUST BE SET TO ENGLISH PRIOR TO FLASHING THE SOFTWARE.
- MySetup variable names were changed in 0.9 - you must configure MySetup part of firmware once again after upgrade !
- If your router seems to hang during the upgrade (upgrade progess bar reaching 100%, and upgrade LED is still flashing red, nothing else happens) - wait at least 5-10 minutes before manually restarting the router !
- Do NOT upgrade via remote internet or wireless connection ! Use only wired LAN connection to upgrade your router ! Double check file sizes and MD5 checksums before upgrading!
- ANNEX B releases are NOT tested - we don't have ANNEX B router ...
- Reboot the router before upgrading to make sure it has enough free memory.
- Disconnect all clients from the router before upgrading. Make sure NO wireless clients attempt to associate with the Gateway until the upgrade process is complete.

And finally, as always: if you are afraid of bricking your WAG200, or don't know how to install and use JTAG - DO NOT REFLASH WITH THIS FIRMWARE ! THIS IS EXPERIMENTAL, BETA SOFTWARE !

0.10 ChangeLog

Changes since 0.9:
- Project name changed to OpenWAG200
- Source tree updated to Linksys 1.01.09 release
- Fixed blank MySetup page problem (thanks to Volkan Kirik)
- Fixed static DHCP problems that appeared in 0.9
- Fixed hard-coded WAN interface name in scripts
- Added mount support for NFS filesystems
- Added connection uptime reporting
- You can execute some commands from ip-up and ip-down scripts (executed when ppp0 is going up/down).
(Create /mnt/mtd5/ip-up and/or /mnt/mtd5/ip-down, and make it executable)
- Minor bugfixes and cleanupsη σελίδα του developer για περισσότερες πληροφορίες http://openwag200.org/