9106 flashed για annex-B.θέλω annex-A ξανά!

[sofia]

γειά χαρά!το ερώτημα είναι το εξής: παλιότερα είχα flasharάρει το usr9106 (δε θυμάμαι με ποιο release) ώστε να δουλεύει με isdn.Πλέον θέλω να δουλεύει με pstn.Κατέβασα τα release 2.3,2.5, μέχρι και το release 1 και το easy configurator μου λέει ERROR: the file you chose does not appear to be valid! Περιττό να πω ότι είχα δοκιμάσει προηγουμένως με browser και τότε τζίφος!Δοκίμασα να πατήσω το reset για 60 sec, χωρίς αποτέλεσμα.Τώρα???

[nnn]

Πάρε το Annex A firmware από το http://www.usr.com/support/9106/9106...elease.2.5.bin

Μετά ακολούθησε τις παρακάτω οδηγίες.

How do I recover the gateway from a crash flash image?

When there is a power failure during software upgrade, the flash image may crash. The USRobotics SureConnect ADSL Wireless Gateway provides a Flash Crash Recovery mechanism to recover the crashed flash image. You must contact your service provider to obtain the current, necessary flash image file.

Recovery Steps:

1. Push and hold for more than 40 seconds the Reset button on the back of the case. After 40 seconds the gateway should reboot and load the recovery image.
2. You need to assign a Static IP Address to your computer, in the same subnet as your gateway's management IP Address. (For example, the default management IP Address for your gateway is 192.168.1.1 The computer IP Address can be 192.168.1.5, subnet mask 255.255.255.0, and gateway IP Address 192.168.1.1)
3. Open a Web browser and type 192.168.1.1 in the Address field. Follow the on-screen directions as demonstrated via the graphic below:

# Close the Web browser, return your computer to Dynamic IP address (the same settings on your computer before you executed Step 2 above) and reconfigure the gateway.

http://www.usr.com/support/9106/9106-ug/troubles.htm